Use a jumper wire to short Circuit 631 (T/R) to Circuit 57 (BK) or to another good ground.located underneath the glove compartment, left side (06010) containing Circuits 631 (T/R) and 57 (BK). Locate the Diagnostic 'Trouble Code Clear' Connector (grey connector).Observe air bag indicator prove-out (six ? two seconds) followed by diagnostic trouble code (52-85) flashing completely one time.Cycle the ignition switch to OFF and then to RUN.Follow the diagnostic procedures to service the fault condition flashing on the air bag indicator prior to code clearing.Reassemble the PAD Module and put it back into the console panel and then put everything back together on the dash in the reverse order of removal.Then you are able to solder on the new LED *polarity matters* with that in mind the negative on the circuit board is closest to the outer edge of the circuit board.Now carefully unsolder the blown light bulb.To prepare the module housing I drilled a 1/4' hole through the clear lens allowing my particular LED to be attached through that hole.Remove circuit board from airbag key module housing.Carefully unclip the plastic tabs that hold the airbag key module case together.Remove 2 phillips head screws to remove the airbag key module.Remove connector from Passenger Airbag Disable module in console panel and take console panel to a work bench.Pull console panel out of the two clips.Using a socket set, remove 4 hex head screws from console panel.Replace side air bag module (LH).(Before disposal, it must be deployed.).Replace the harness if it has visible damage.Visually check the wiring harness connection.

Firing circuit, belt tensioner, passenger's side #04 Airbag Code Repair order ('Recheck SRS at each replacement.')

Firing circuit driver airbag stage 2